PDA

View Full Version : TA05 Version 2


TimPotter
10-15-2009, 08:11 AM
Does anyone have a list of Speed Controller that will fit in the v2 ?
akuntze
10-16-2009, 08:45 AM
With some thoughtfulness, my LRP Sphere TC fits fine. I just shoe-goo the on/off switch to the side of the heat sink and the capacitor to the other side.
TimPotter
10-16-2009, 01:15 PM
I know my Sphere fits in my 05R, but my SP 2.0 ... needs quite a bit of Dremel work ot get it in there.

I guess I am out of luck on the v2 ?
akuntze
10-16-2009, 02:52 PM
I am not familiar enough with that esc to give you a definite answer. I do know that they narrowed up the chassis quite a bit, and because of the new motor mount, did loose room for electronics installing.:confused:
GreyMachine
10-16-2009, 04:10 PM
To my eyes, there's still plenty of room for most ESCs in the V2. I have one and my old school LRP IPC V6 fit right right in there, so I'd imagine almost any on road racing speed control made in the last several years would fit.
TimPotter
10-21-2009, 12:26 PM
Behind the motor ?

I had to do a fair amount of dremeling to get the speedo into my 05r.. so I cna only imgine it would be near impossible to get it in the vII. At least in it's intended spot.


To my eyes, there's still plenty of room for most ESCs in the V2. I have one and my old school LRP IPC V6 fit right right in there, so I'd imagine almost any on road racing speed control made in the last several years would fit.
GreyMachine
10-21-2009, 05:00 PM
Hm, that's strange. Well, in case it helps, the dimensions of my IPC V6 are 41mm X 36mm, which again leaves a little breathing room. And yes, I have it in the proper spot behind the motor.
prorace
10-30-2009, 08:14 AM
I have a mamba Max in my TA05R, and It needed some dremeling, to fit in...
kwkride
10-30-2009, 10:12 PM
I have a Novak Havoc in my TA05R and it wouldn't fit down into the spot for the ESC. I had to put to put an extra piece of plastic down in there to fill in the gap between the chassis and the bottom of the ESC.

Jim
Tsal
10-31-2009, 12:38 PM
I run brushed motors still:LOL: So my Tekin FXR fits with plenty room to spare.http://i571.photobucket.com/albums/ss152/tommysal/CIMG4578.jpghttp://i571.photobucket.com/albums/ss152/tommysal/CIMG4577.jpg